Safety Eligibility Letter B-248

U.S. Department of Transportation
Federal Highway Administration

1200 New Jersey Ave. S.E.
Washington, D.C. 20590

March 27, 2014

In Reply Refer To:
HSST/B-248

Mr. Barry Stephens
Trinity Highway Products, LLC
3617 Cincinnati Avenue.
Rocklin, CA. 95765

Dear Mr. Stephens:

This letter is in response to your request for the Federal Highway Administration (FHWA) to review a roadside safety system for eligibility for reimbursement under the Federal-aid highway program.

Decision:
The following device is eligible, with details provided in the form which is attached as an integral part of this letter:

• Modified Thrie Beam Blockout

Based on a review of crash test results submitted by the manufacturer certifying the device described herein meets the crash test and evaluation criteria of the National Cooperative Highway Research Program (NCHRP) Report 350, the device is eligible for reimbursement under the Federal-aid highway program. Eligibility for reimbursement under the Federal-aid highway program does not establish approval or endorsement by the FHWA for any particular purpose or use. 

The FHWA, the Department of Transportation, and the United States Government do not endorse products or services and the issuance of a reimbursement eligibility letter is not an endorsement of any product or service.

Requirements
To be found eligible for Federal-aid funding, roadside safety devices should meet the crash test and evaluation criteria contained in the National Cooperative Highway Research Program (NCHRP) Report 350 or the American Association of State Highway and Transportation Officials' Manual for Assessing Safety Hardware (MASH).

Description
The device and supporting documentation are described in the attached form.

Summary and Standard Provisions
Therefore, the system described and detailed in the attached form is eligible for reimbursement and may be installed under the range of conditions tested. Please note the following standard provisions that apply to FHWA eligibility letters:

• This letter provides a AASHTO/ARTBA/AGC Task Force 13 designator that should be used for the purpose of the creation of a new and/or the update of existing Task Force 13 drawing for posting on the on-line 'Guide to Standardized Highway Barrier Hardware' currently referenced in AASHTO Roadside Design Guide.
• This finding of eligibility does not cover other structural features of the systems, nor conformity with the Manual on Uniform Traffic Control Devices.
• Any changes that may influence system conformance with NCHRP Report 350 criteria will require a new reimbursement eligibility letter.
• Should the FHWA discover that the qualification testing was flawed, that in-service performance reveals safety problems, or that the system is significantly different from the version that was crash tested, we reserve the right to modify or revoke this letter.
• You are expected to supply potential users with sufficient information on design and installation requirements to ensure proper performance.
• You are expected to certify to potential users that the hardware furnished has the same chemistry, mechanical properties, and geometry as that submitted for review, and that it will meet the crash test and evaluation criteria of the NCHRP Report 350.
• To prevent misunderstanding by others, this letter of eligibility is designated as number B-248 and shall not be reproduced except in full. This letter and the test documentation upon which it is based are public information. All such letters and documentation may be reviewed at our office upon request.
• This letter shall not be construed as authorization or consent by the FHWA to use, manufacture, or sell any patented system for which the applicant is not the patent holder. The FHWA does not become involved in issues concerning patent law. Patent issues, if any, are to be resolved by the applicant.
• Because it is a steel product, the Modified Thrie Beam Blockout is subject to Section 635.410 (Buy America) of Title 23, U.S. Code of Federal Regulations, and cannot be permanently incorporated into any federally funded project unless it is made in the U.S. from U.S. steel.

Enclosures